This Simple Bunk Bed is basically two Simple Beds stacked to make bunks! The beds can be used as twins as well. Super sturdy design, classic slatted styling. Our free step by step plans include diagrams, shopping lists and cut list. Lots of reader submitted photos!
CollectionsReader submitted photo
Dimensions
Materials and supplies to make two Simple Beds
Common Materials 1 1/4 inch screws 2 inch screws 3 inch screws 120 grit sandpaper wood conditioner paint brushFollow the Cut List for the Twin Simple Beds
Cutting List for 1 Guardrail
A) 3 – 1×3 @ 44 3/4″ (Rails)
B) 2 – 1×3 @ 14 1/2″ (Outer Posts)
C) 4 – 1×2 @ 2 1/2″ (Spacers)
D) 2 – 1×3 @ 10 1/2″ (Inside Posts)
Cut List for the Ladder
2 – 2×4 @ 58 3/4″ (Sides, ends cut at 30 degrees and 60 degrees as shown in the diagram below)
6 – 2×4 @ 18″ (Treads)
You will need to begin by making two Simple Beds from these plans.
Build two simple beds, but construct the beds with both footboards to the top bunk, and both headboards to the bottom bunk. Notice how the header for the bottom bunk is shown in purple? That’s because the easiest way to join these two beds is to attach the bottom bunk’s headers to the bottom of the top bunk, as shown in the above diagram. Then when you assemble the bunk beds, simply screw through the top of the header into the top of the bottom bunk headboard. Super easy! To do this, first attach the bottom bunk’s header to the legs of the bottom bunk using 3 – 4″ screws per leg. Predrill first. When you assemble the beds, make sure you countersink and predrill the header into the bottom bunk’s 1×6 trim. Also for each of the legs, screw at an angle from the top of the header into each of the bottom bunk’s legs. In this method, you can also unassemble the bunk beds and use as twin sized beds later.
In addition to the bunk beds, I also drew up plans for the guardrails and the ladder. You can adjust the length of the guardrails and width of the ladder as you see fit. These measurements are similar to the Land of Nod Simple Bunk Bed Guard Rails and ladder.
Cutting List for 1 Guardrail
A) 3 – 1×3 @ 44 3/4″ (Rails)
B) 2 – 1×3 @ 14 1/2″ (Outer Posts)
C) 4 – 1×2 @ 2 1/2″ (Spacers)
D) 2 – 1×3 @ 10 1/2″ (Inside Posts)
This cut list and instructions is for 1 guardrail, 44 3/4″ long. You may wish to increase the length of the guardrail to fit your needs. You may also wish to sand all of your pieces prior to building the guardrail. Attach the top rail, spacer, middle rail, spacer, and bottom rail to the outer posts as shown above. Keep the top rail flush with the top of the outer posts. Use 1 1/4″ nails and glue. Nail from the inside into the inside edge of the outer posts. Keep end edges flush. Check for square (See HOW-TO section)
Inner Post. Attach the inner post to the Guard Rail. Attach the inner post as shown above. Keep outside edges flush. Use 2″ Nails and glue.
Treads. Use 3″ screws (2 per tread per side) to screw the treads in place as shown above. Predrill and countersink your screws. To attach the ladder to the bunk bed, simply predrill and screw through the top of the sides into the side rails of the top bunk.
Project Typemelissa (not verified)
Fri, 01/15/2010 - 20:35
thank you, thank you, thank you! this is awesome. i will send pictures/feedback along as soon as we are done building these bunkbeds for our girls! i am beyond excited!
Ana White (not verified)
Fri, 01/15/2010 - 23:00
I just want to make everyone aware that commercially produced bunk beds must meet specific safety standards. While I did build this plan very close to the dimensions of the Land of Nod Simple bed, this is not exactly the same bunk bed. This bed has not been tested to those specific standards. Build at your own risk. The information provided is purely a representation of how I would build a bunk bed, and not a recommendation of any sort.
Marcella (not verified)
Fri, 01/15/2010 - 23:27
thank you ana! i can't wait to build these!!
Kimara@weefolkart (not verified)
Sat, 01/16/2010 - 05:19
I am so excited to have found your website several days ago. I'll be linking on FaceBook. Thanks for your time and generosity.
Anonymous (not verified)
Sat, 01/16/2010 - 05:32
Are there any mattress cross supports in these plans? I'm not seeing them.
Laree (not verified)
Sat, 01/16/2010 - 06:05
ACK! I had decided to just make the stratton day beds for my kids, since I couldn't find bunk beds that I liked. Now I totally have to re-evaluate my whole plans. Too many options!
You are amazing!
Miranda (not verified)
Sat, 01/16/2010 - 07:22
These are beautiful! My kids already have bunk beds though, but what caught my eye were the book holders hanging on the wall for each child. Any chance you could do some plans for those?
jdreier (not verified)
Sat, 01/16/2010 - 07:40
Ha! I was thinking the very same thing about those book holders. I gotta have some!
Kim & Corey Nasfell (not verified)
Sat, 01/16/2010 - 07:56
THANK YOU. Oh I can't wait to show my husband (and convince him to build me a set)! :) So. since we've never built ANYTHING before would you mind telling me what kind of wood you would recommend buying pretty please?
Ana White (not verified)
Sat, 01/16/2010 - 09:52
Slats for the mattress. See the plans for the simple bed. You will simply need to attach 2x2s every 1 1/2" to the cleats on the inside edge of the side rails. You can of course use a bunk bed box spring (which is essentially the same as the 2x2s but covered in fabric).
Also note you will need to use a top bunk mattress on the top bunk. This can be different than a regular mattress - top bunk mattresses are thinner.
Ana White (not verified)
Sat, 01/16/2010 - 09:54
Wood - check out Toni's bed on the bragging board, it's made of pine. Of course you can use any type of wood you choose. But pine is cheap, strong, and readily available.
Ana White (not verified)
Sat, 01/16/2010 - 09:58
Plans for Collector Shelves from Pottery Barn kids, similar to the shelves shown in the Land of Nod photo can be found here:
Save your scraps. You won't need much to build these collector shelves! Enjoy!
~ RM (not verified)
Sat, 01/16/2010 - 11:02
Oh, this is great. Thanks for the plan. Although, haha, I couldn't help but think of Stepbrothers and their bunk bed fiasco! lol
Sandy (not verified)
Sat, 01/16/2010 - 11:34
I'm a new visitor to your blog and I'm blown away. I love all the tips ( getting home depot to do the cutting) and great ideas.Just to let you know I'll be back.
Jen Kesler (not verified)
Sat, 01/16/2010 - 14:47
Thank you so much for sharing all of your fabulous ideas! What a HUGE treat.
Wishful Thinking (not verified)
Sun, 01/17/2010 - 09:38
Wow, I've recently come across your blog and I'm blown away. You're so inspirational. I have just started a blog about what I call "bumbling through domesticity" because I'm always messing up home-care projects. However, I rarely mess up twice in the same way! Now your website has given me something to work toward. Instead of saving money over time for some really nice piece of furniture, I can save up knowledge and courage (yes! I'm scared of saws right now!) to make it myself. Thanks a lot!
Gretchen (not verified)
Sun, 01/17/2010 - 11:10
I just spent half the day going through your blog. Nearly everything I've wanted to make from PBK is here! I'm so excited. I think DS's bed will be a simple bed when he is ready for one.
On the guardrails, how are they attached to the bed? I read a few times but can't figure it out. They look much nicer than a toddler rail and may add those on just to keep him in.
The Hatch's (not verified)
Mon, 01/18/2010 - 10:43
I had just come to your blog to ask you how we night go about making the simple bed into bunk beds and voila you already had it up. Thank you Thank you Thank you!! I love your blog!
Ana White (not verified)
Mon, 01/18/2010 - 15:20
FASTENING GUARD RAILS >>>>>>>>>
The easiest and cleanest way to fasten guard rails is to position the rails where you would like them to rest, and then from the inside of the side rail, using 2 1/2" screws, predrill and fasten through the side rail into the guard rail outer post. This will hide your screw holes and make removing the guardrail a cinch.
Chatter (not verified)
Fri, 01/29/2010 - 08:57
Thank you, thank you, thank you!! I have been on the search for bunk beds for my boys. However, I'm going to (with the help of my hubby) modify the bottom to be a full size bed. Any tips or suggestions?
I was just given your blog 2 days ago and I'm loving all the projects we will hopefully tackle soon. Thank you so much for sharing your knowledge with us!! Much appreciated :)
Chandra
p.s. I'll try to post our progress once we get started.
Jenny (not verified)
Tue, 02/02/2010 - 07:57
Quick question. what height are we to cut the headboard and footboard 4x4's now. In the Simple Bed plans, the headboard and footboard are different heights.
Jenny (not verified)
Tue, 02/02/2010 - 07:59
NEVERMIND! I see now that you used both footboards as the headboard and footboard on the top bunk. DUH!
Clarke (not verified)
Fri, 02/12/2010 - 04:34
I recently came accross your blog and have been reading along. I thought I would leave my first comment. I dont know what to say except that I have enjoyed reading. Nice blog. I will keep visiting this blog very often.
Melissa (not verified)
Wed, 02/17/2010 - 12:49
Would it work to do the same thing with the full size simple bed plans to have full over full bunks? I'd love these in my boys' room and the twin size in the girls' room. I'm hoping to build the two sets of bunks this spring when it warms up.
lindsy (not verified)
Wed, 02/17/2010 - 20:35
You are amazing! I love your blog. Do you think I could make these bunk beds in the Farmhouse Twin style? It looks like the measurements would be a little different (leg lengths). Anything else I would need to do differently? Thank you!! I can't wait to start!
Joanna (not verified)
Wed, 03/03/2010 - 05:51
These bunk beds look amazing! I am definitely putting these on my to-do list when we need to add another bed to the room. Thanks!
Anonymous (not verified)
Sun, 03/14/2010 - 17:17
Ana, you're amazing! My husband has just started woodworking again. He has a beautiful bench he just finished for my son and daughter-in-law. My grandson is just 16 mos. old but this bunkbed is certainly in his future. Our comments inspire you and you inspire us!
Anonymous (not verified)
Tue, 03/16/2010 - 14:23
I was wondering if you could make this bed into a type of mid height loft bed?
Wendy (not verified)
Wed, 04/21/2010 - 03:51
Love the bunkbeds. Any hints on how to adapt these plans to a single over a double or queen size? It will look great in our now empty bunkhouse at the cottage. Thx. Great blog.
Ana White (not verified)
Wed, 04/21/2010 - 05:43
To do a full over twin, simply build two twin foot boards and two full headboards and assemble the bunk as directed in the plans. A reader in the brag board already did!
Karen (not verified)
Sat, 05/01/2010 - 15:12
Thanks so much for posting these plans (and all the other awesome plans). I built and painted this bunk bed set over the past 2 weeks, and my husband and I are assembling them now. One tiny problem though. in the diagram it shows a ladder of 67"ish, and the plans are for a ladder that is 58"ish. I'm guessing it would match the other bunk bed you've got up here, but it is too short for the simple beds as bunk beds (or I managed to somehow misread the directions and end up with a perfect but too short ladder). We will rig something up to make this work, possible incorporating another step that can be used separately for potential future use for a not yet existing toddler when the bed is not bunked. Just thought I should mention my situation for others to consider when building. But I will post pictures when it is all finished (It's really beautiful!). I'm so proud of it, and I can't wait to brag :) Thanks again, Ana!!
Jen Morris (not verified)
Thu, 06/24/2010 - 20:35
you don't happen to have plans for the turquoise bunk bed in the middle of this blog, do you?
Laura (not verified)
Wed, 07/28/2010 - 05:13
Was wondering if you could tell me how movable this bunkbed is? I really need a bunkbed for my boys, but my husband is in the military, so I need to make sure I have something that can be taken apart and be put back together without too much hassle. Thanks!
Brandi Barnes (not verified)
Sat, 07/31/2010 - 08:29
Karen, I wish I would have read your comment about the ladder before we built ours. Our son went out of town overnight with my in-laws and we have been working like crazy to get his bunk beds assembled only to find that the ladder is way too short once we got the beds stacked. That meant another trip to the lumber yard this morning and I just got the first coat on the new ladder. Other than the wrong length for the ladder everything has gone together great! I love the beds and can't wait to share some pics!
Brandi
Wed, 09/08/2010 - 08:02
[. ] converted to twin beds. If you would like plans for twin beds that can be converted to bunk beds, go here. Also go here for plans for the ladder and guardrail. Shopping List 13 – 2×6 Boards, [. ]
The Perrins (not verified)
Sun, 10/31/2010 - 11:16
